Knox Krypton 7200 6kW Hybrid Inverter

Knox Krypton 7200 6kW Hybrid Inverter

Full specifications

Brand
Inverter Specifications
ModelKrypton 7200
Inverter typeHybrid
Grid typeSingle Phase
PV Input Data
Max DC input power7200 W
PV input voltage500 V
MPPT voltage range120-430 V
Max. PV input current27 A
No. of MPPT1
Startup voltage120 V
AC Output Data
Rated AC output6000 W
Rated AC output current26 A
Rated voltage230 V
Smart load / generator inputYes
Parallel operationYes
Power factor>0.99
Battery Data
Battery typeLithium & Lead-Acid
Battery voltage range48 V
Max. charging current120 A
BMSUSB / RS232 / RS485 / WiFi / Dry-contact
General Specifications
Weight12 kg
Operating temperature-10°C ~ +50°C
Max. efficiency95%
Size (W×H×D)295 × 468 × 120 mm
Note: Takes up to 7200 W of PV. 6000 W output on a 48 V bank from one MPPT with a 120 to 430 V window (360 V nominal, 500 V maximum) and 27 A input current (40 A maximum), starting at 120 V and feeding the grid from 150 V. Grid feeding over a selectable 184 to 264.5 V or 195.5 to 253 V window. 120 A from solar and from mains, 26 A nominal output current. Float charge 54 V, overcharge cut-off 63 V. Parallels to 9 units in the table, although the front page says 6. The datasheet leaves the surge figure blank for this model; the Krypton 7500 beside it is rated 12,000 VA. Knox name the base model as the Hybrid Infini VII 6kW-48V. 12 kg in a 295 × 468 × 120 mm case. Knox's datasheet files the whole Krypton range under a Grid-Tie Operation section with grid feeding, so it is listed as a hybrid, but it names no grid certification (no IEC 62116 anti-islanding or IEC 61727), so confirm your distribution company will accept it for net metering before planning an export system. Pure sine wave output with a 10 ms transfer for computers and 20 ms for appliances, 93% battery-mode efficiency and 95% maximum DC to AC conversion. Dual outputs for smart load management, a 12 V DC output of up to 100 W for a DC fan, LED lights or a router, RGB status lights, built-in WiFi with an Android and iOS app, USB on-the-go, and a reserved BMS port (RS485, CAN or RS232). It runs without a battery and accepts mains or generator input, restarting on mains once it returns to 180 V. Replaceable fan and a built-in anti-dust kit. Rated -10 to +50 °C. The datasheet gives no IP rating and no warranty term, so ask the dealer for both. No price is shown: no Pakistani retail listing with a current price was found on 21 September 2026.